Shanghai Jsave New Materials Technology Co., Ltd.

 

Banner
Home > News > Content
Injection molding machine Insulation sleeve Manufacturers talking about injection molding machine insulation sleeve
- 2018-12-03-

Energy savingInjection molding Machine Insulation sleeveis a commonly used insulation equipment, injection molding machine insulation sleeve manufacturers of insulation sleeve not only has the characteristics of high efficiency and energy saving, but also has the advantages of good insulation effect, injection molding machine insulation sleeve manufacturers discuss energy-saving injection molding machine insulation sleeve.

As we all know, the equipment in the operation of the inevitable will produce a certain amount of heat, but the need to pay attention to the demand is too much heat will lead to the machine constantly heating, this invisible will increase the cost of electricity, thus incurring an increase in capital. On the market a power of 3200 watts of injection molding machine, in the absence of the use of our manufacturers to consume insulation sleeve on the premise of its electricity consumption of 1.6 degrees, but in the use of our removable insulation clothing sales manufacturers to provide energy-saving injection molding machine insulation sleeve when its electricity consumption is only between 0.6 degrees to 1.0 degrees. The above experiments have proved that the use of our removable insulation clothing sales manufacturers to provide energy-saving injection molding machine insulation sleeve for you to save more energy, its frugal rate of more than 20. This is not comparable to other manufacturers ' products.

When using the insulation sleeve, we should first use the gas filtration method to verify it, and check the service life of the insulation sleeve. Experiments show that we can not expose the filter sleeve to air or high temperature, because it will occur oxidation, resulting in changes in the composition of the filter sleeve, it is also important to note that when using the insulation sleeve, we have to ensure that the temperature must not exceed the film Zui large temperature limit. In order to avoid contact with the high temperature stainless steel sleeve surface, we should wear the appropriate device in the construction. such as glasses and protective gloves. For the maintenance of the insulation sleeve, there is no special maintenance method, we only need to pay normal attention to it, once found that the insulation sleeve on the top of the dust or moisture, just clean it up can be.

Shanghai Jsave New Materials Technology Co., Ltd.

Contact Us

     

    Shanghai Jsave New Materials Technology Co., Ltd.


    Tel: 021-51090806


     Email: lee@jsaveinsulation.com


    Kunshan Production Base: No. 19th Gong Lane road, Shipu, Kunshan, Jiangsu Province


    Jiangxi Production Base: No. 6th Chun da Lu, Yuanzhou Economic and technological development zone, Yichun, Jiangxi Province

Mobile